Where is the shrinkwrap?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Where is the shrinkwrap?
Honestly, it says right here that REV3 blah blah SW0002 HAS BEEN SAVED but a search fails to find it anywhere?
I know I could make another one but I should not have to!
WHERE HAS IT BEEN SAVED?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Solved! Go to Solution.
- Labels:
-
Assembly Design
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Vince,
(in Creo 2.0) just start creation of another shrinkwrap, discover target directory in Save a Copy dialog box and cancel the action.
Martin Hanak
Martin Hanák
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Vince,
(in Creo 2.0) just start creation of another shrinkwrap, discover target directory in Save a Copy dialog box and cancel the action.
Martin Hanak
Martin Hanák
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Vince,
Did Martin's response resolve your question?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Thanks Martin.
I also learned that when I allow the SW to be saved to the default location it's easy to find in Windchill in the "content" tab of the details page of the part or assembly.
In hindsight that one was pretty obvious.
We don't see an immediate need to have the shrinkwrap attached but maybe for a future reference model.
