Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
More of a statement than a question, but I was looking to add an external merge geometry to a part that would ultimately end up in sheet metal mode.If I convert the part to sheet metal mode first, then I only have the option to add the geometry as an inheritance.The merge/ inheritance toggle button is grayed out. If I add the external merge in standard mode, I have both options (merge or inheritance).I can select merge and then convert the part to sheet metal mode.
WF3.0
Just wondering if anyone has seen or know why this works this way.
Patrick Fariello
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
