Tell me that PTC has a way to change the attachment of this in Creo 2. Please?
[cid:image001.png@01CE56FE.322328D0]
When are they going to fix this so the flatness can be move either below or above the datum. It's not correct as shown.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
