"All Instances" in Creo Pro

TomD.inPDX · ‎Sep 17, 2012

What happened to the "apply to all instances" option when you round or chamfer a patterned feature?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

BrianMartin · ‎Sep 17, 2012

Hmmm... I'm actually not familiar with this one! I know there was a feature to add all instances of a component to a family table - or just one. I'm not sure I recall being able to add a round to all instances of a pattern. Usually when you attempt to pattern a round along a feature which has, itself, already been patterned, the round just does a "ref pattern" automatically.

In what context did you see this command previously... maybe that would refresh my memory?

Thanks!

-Brian

TomD.inPDX · ‎Sep 17, 2012

2000i; I seem to remember that this was an option in the feature creation dialog.

BrianMartin · ‎Sep 17, 2012

I might be able to pull out memories from i2... but I actually never used 2000i for more than about a month before we upgraded. We went from 20 to i2 in rapid succession.

You're going back like... 13 years. I was still in my twenties!

I'll have to admit defeat on this one... I have no idea about this command.

TomD.inPDX · ‎Sep 17, 2012

It happens to the best of us, Brian

I'm second guessing myself on this one too, but I'm pretty sure this was part of 2000i.

I have no way to go back to that version to confirm.

Anyone else have a similar recollection?