simulation problem on connection part

[ptc-5074877]

Hello everyone,

I met a problem when doing simulation on the connection part. I tried to provied some force on the connection interface(see the attachment), but the analysis failed and the diagnostics says : Run completed with fatal error. Do you have any suggestions on that?

Thanks a lot:)

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[346gnu]

Hi,

Your constraint is fully fixing the surface.

Your load is acting on the same face.

The constraint will win and nothing will happen.

The software will warn of this load/constraint conflict in the diagnostics.

This load/constraint conflict is not the reason the model fails.

There is another problem somewhere.

Regards

[ptc-5074877]

Hi ,

Thanks for your reply, I fixed that and it works now