Where to find decent tutorial for Schematics 10.0.0

[TH_14207554]

I am getting frustrated finding good tutorials for Schematics.  I need to generate a Wiring Diagram(s) for a test rack.  I have to generate multiple complex custom components (artifacts?) with large numbers of connections.  I have done the artwork and have it in .DXF format.  I have fought through and figured out how to load the DXF's into the editor, but I need how to figure out how to take the DXF and do pin assignments and make it a reusable stand alone component to put into a library for reuse.  Does PTC have any online tutorial for Schematic?  I am running 10.0.0.  I find tutorials for some parts of this but they are years old and the instructions don't match the new rev.  This ain't my first rodeo, but the inability to find instructions, or tutorials has me frustrated.

[VladimirN]

"Creo Schematics 10.0.0.0 Help Center": https://support.ptc.com/help/creo_schematics/r10.0/en/ 

[anursingh]

Hi @TH_14207554,

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation. 

Thanks,
Anurag 

[TH_14207554]

I was in the process of qualifying Schematics for use by our full Test Engineering Staff. I was frustrated by the lack of reasonable tutorials or manuals. I signed up for an online class with PTC. I went to login to the class and apparently it was canceled with no notification.

You missed your opportunity. I am recommending we go with Autodesk Electronics instead. Their interface is far more intuitive and easy to use.

[Matt_Huybrecht]

Hi,

Have you looked at this free playlist on Learning Connector?

Get Started with Creo Schematics Catalogs

Maybe it has what you're looking for.

I reached out to the scheduling folks for the LEARN course you mentioned, Introduction to Creo Schematics for Cabling, Looks like it ran on September 26th at 3:00 AM EDT as scheduled. They do show you as having signed up for it but not attending. Maybe you thought it was at 3:00 PM instead of 3:00 AM? There is another delivery on October 16th at 1:00 PM EDT if you wanted to give it another go (the October 10th course is full).

I'm not much of a Schematics user but I would guess this class probably won't have what you're looking for. This course is more for users and doesn't cover anything on the admin side with catalog creation. 

PTC typically recommends that customers looking to implement Creo Wire Harness Design engage with one of our partners to help guide them through the implementation and catalog development process. I'm happy to provide contact information if you would like it. Just let me know.

Regards,

Matt

[TH_14207554]

Don't bother, I canceled the adoption of CREO Schematics for our department.

Get real, 3:00 in the morning?

[Matt_Huybrecht]

3:00 AM EDT = 9:00 AM in Europe = 12:30 PM in India

There are Creo Schematics users all over the world and we support them during their workday.