Barrel cam motion test-01
Dec 28, 2011
04:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dec 28, 2011
04:34 PM
Barrel cam motion test-01
These are videos I made to simulate a barrel cam I reverse-Engineered from looking at how a particular "cammed over-center" latch worked without being able to actually take it apart.
Part -01 showing the trajectories.
Sorry it's so simple, but it was my first (and only so far) try using the Mechanism constraints. But, it works, and seemed to be pretty advanced as far as motion goes as the guy presenting a demo on Mechanism didn't have any idea how to do it.
Unable to play video. Please try again later.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
Dec 29, 2011
03:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Dec 29, 2011
03:22 AM
Your video proceeds only 3 seconds!
