Interface Force calculation for CREO Simulate
‎May 07, 2020
12:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 07, 2020
12:18 AM
Interface Force calculation for CREO Simulate
Hi All,
I have doubt for Interface Force calculation at Contact Area in Creo Simulate.
1. What is the Unit of Interface Force & Interface Area (for mmNs) ?
2. Larger the Contact Area, Smaller the force.
3. If I divided the contact area into specific contact area zone (Using Volume region), Interface force is increasing, why ?
4. What is difference between Component force & Surface to Surface force ?
Can anyone help me to understand above point. After solving one CREO Simulation it look Like got very high interface force practically which is impossible.
0 REPLIES 0