cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Pipe thread model

rcrisp
1-Newbie

Pipe thread model

Proe Users,



I have a co-worker that needs to model in pipe threads for a cast model. Is
the Helical Sweep > Variable the option that allows taper on the threads,?
It has been years since I last did this. Anyone have a simple model they
could send as an example I could give to him to use as reference, I am too
busy to help him right now.



Thank you



Ryan Crisp | Senior Mechanical Engineer

Priority Designs
501 Morrison Rd.
Columbus, OH 43230
(614) 337-9979
<">http://www.prioritydesigns.com> www.prioritydesigns.com

CONFIDENTIALITY NOTICE: This email along with any attachments contains
proprietary information, some of which may be legally privileged. If you are
not an intended recipient of this email, you must not disclose, copy or take
any action in reliance of this transmission. If you received this email in
error, please contact the sender and permanently delete all copies of the
email and any attachments.




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
dgallup
4-Participant
(To:rcrisp)

No, you don't want variable, that is for variable pitch. Just draw the profile at an angle.
Top Tags