cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

CREO2 : Groove to circles

ldrutel
12-Amethyst

CREO2 : Groove to circles

Bonjour,

Existe t-il une manière plus rapide de transformer une esquisse de lumière en 2 cercles ?

L'esquisse de départ est une lumière (1) et je souhaiterais arriver à 2 cercles (4), sans perdre la cote de 38 mm.

Ma méthode a été de supprimer les 2 traits droits (2) , de placer 2 traits d'axes et d'aligner les bords des axes dessus (3) et enfin de compléter l'esquisse par 2 bouts d'arcs (4)

----------------------------------

Hi,

Is there a faster way to turn a groove sketch two circles ?

I would like transform an Initial sketch whitch is a grovve (1) as 2 circles (4) without lost cotation 38 mm.

My method was to remove two straight lines (2), placing 2 axes and align the top edges of the axes (3) and finally to complete the sketch by 2 pieces of bows (4)

Groove vs Circle.bmp

2 REPLIES 2
John.Pryal
14-Alexandrite
(To:ldrutel)

Hi, you could leave the initial groove sketch intact, but make all the entities construction. Select all the entities, RMB, pick construction. Then simply sketch 2 (geometry) circles over the top of the construction arcs until they snap to them.

Hope this helps

John

ldrutel
12-Amethyst
(To:John.Pryal)

Thank you for your solution

Great day

Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags