Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
I think I have seen this before. Notice that the value in the properties box does not match the highlighted value on the drawing. I would clear the drawing out of session and call it back up.
It looks like mm are shown in the box, while inches are shown on the drawing. Your config file probably is set to show (-1) between primary & secondary units.
SOR(r) invites you to visit its display of oil & gas instrumentation products at the Offshore Technology Conference May 4 - 7. We are located in the Reliant Center at booth number 2541-14 in the United Kingdom (UK) Pavilion. For the Sales Representative in your area, visit www.sorinc.com
It looks like your primary units are mm and secondary is inches and our *.dtl file is set to show secondary only. There's a drawing option to control the difference in decimal places between the primary and secondary units: dual_digits_diff -1 -1 is the common setting for inch primary and mm secondary, which is the opposite of what you are doing. You may want 0 or 1.
