Where is Compatibility Matrix?

[bpeters]

Good day,

Does anyone know how to locate the Compatability Matrix on the PTC website?

Thanks, Bruce

[ptc-17944]

Brad Hacker
Sr. PLM/PDM/CAD Admin
Zebra Technologies Corp.

[ptc-171472]

Go to www.ptc.com

[mbraaten]

For which products? Try here:

[ptc-171472]

Go to PTC Website and select the SUPPORT tab at the top of the page.
Under the SELF HELP section, select DOWNLOAD REFERENCE DOCUMENTS.
Set DOCUMENT TYPE to MATRICES SOFTWARE and select the BROWSE
button.

To create a shorter list you can also set the PRODUCT on the Browse
page.



Michelle McMasters
Engineering Systems Administrator
michelle.mcmasters@bdhhi.com

IMPORTANT NOTICE: This message is intended only for the use of the
individual or entity to which it is addressed. The message may contain
information that is privileged, confidential and exempt from disclosure
under applicable law. If you are not the intended recipient, you are
notified that any dissemination, distribution or copying of this
communication is prohibited. If you have received this communication in
error, please notify the sender immediately. Thank you

[kveeser]

Morning Everyone,

I would like to create a standards & procedures manual for our company in
ProE and Intralink. does anyone have a company manual they could share
with me? I would like to get some ideas from other administrators or
companies on how to create a manual.

Thanks in advance,

Kevin Veeser
Design Engineer
Hatco Corporation

[dpilkey]

Kevin,

If you don't mind I would also like to take a look at these if you get
any.

Thanks

Donald

[ben_loosli]

There was a discussion of CAD standards on the exploder in early May in
the old Model forum.

Ben Loosli
Sr IS Technologist
Engineering Automation Systems
L-3 Communications/Integrated Systems
Waco, TX 76715

254-867-4069
-

[roger.willson]

And an excellent presentation the past couple of years by Sir Pitts...

[mreece]

There is an advantage with the new portal implementation.... I have
never subscribed to the modeling forum as most of their topics are not
of interest to me. But as an administrator, CAD standards are of great
interest to me! and I will now have visibility to those posts.

Does someone have the summary that they can share?

Thank You.