round failed or not
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
round failed or not
I think it means that it "assumed" to have found a replacement edge for the one I redefined.
I don't know that I like it making those assumptions but it was right this time, but I specifically remember one the other day that it assumed incorrectly. No failures, it just moved my round and the software was happy happy happy...but I was not particularly pleased.
[cid:image001.png@01CF5A25.4AD979D0]
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
attention.
Michael P. Locascio
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi Michael,
I realise this is a stale thread but I couldn't see anything else related (probably poor searching.
Do not look at the forum daily as I used to when it was all on the exploder (or even weekly, or monthly).
Anyhow I wonder about this functionality. Sure I understand that the rounds I had have been reassigned to other edges, due to my remodeling, by some PTC algorithm and that sometimes it can choose wrong. What I want is a function that when I look in my round and see some orange dots I can verify them as acceptable and thereby remove the orange dot. For a long time now I have either deleted all the orange dots and remade those references or sometimes I have left them if time was tight and remaking references on something that worked was not best use of my time.
In short I want to scan through the list then be able to RMB and have an option to either delete or accept the orange references.
Hope this makes sense.
Regards, Brent