Hey all,
Hopefully someone might of had something similar happen to them. We have a number of mould machines, ranging from kraussmaffei, fanuc, engel etc....
We have a reoccurring issue where the kraussmaffei mould machine (Connected to Kepware via Euromap 63) gets shut down for batch changes or maintenance, After a couple hours, the whole of kepware will go down for all the other moulds.
We tested this by disabling kepware for the kraussmaffei machines, and not had any issues since. But we've been unable to narrow down, or really begin on what could be causing this. Any suggestions on where to begin? What to look out for in the event logs? What causes "bad data quality" to the point it breaks?
