Changue 3D Annotation Orientation

[Ed13]

Hello every body,

When I create a 3D annotation in V.18 between two center holes, the new 3d annotation is perpendicular at  the base face of the holes (it is automatically). Can I changue this position and put parallel at the base face of the holes?

I try to do with orient 3D annotation command, but it is not possible.

Any solution?

Thanks in advance.

Regards.

[ThomasKirkman · Accepted solution]

I think i understand the question. You want to pick user def. and use an edge, axis, or other geometry to define the direction.

Tom

 

[Ed13]

Perfect Tom!!!

Thank you very much.

I have to activate first the 3D Documentation Module, here I find your answer (user def.pick).

Good support.

Best Regards.