Convert .pkg to .iges

[SC_12205882]

Hello Community members,

Im a new in this community.

Im wrote from Italy and I have a question for your.

Can I converted a file .pkg to .iges, .stp, .pk2, .prt or .assembly ??

Thank you for support.

Enrico.

[KenFarley]

If you did a search on this site you would find a similar question:

https://community.ptc.com/t5/3D-Part-Assembly-Design/Opening-PKG-file-in-Creo-Parametric-9-0/m-p/851828 

which ultimately suggests looking at this:

https://www.ptc.com/en/support/article/CS134024 

One would presume that if a .pkg file can be read into Creo, it could then be output in whatever formats Creo will write.

[Kotom-Eng]

Just to be sure, what software are you using,   Creo+ / Creo Parametric    or     Creo Elements Direct Modeling  ?

[anursingh]

Hi @SC_12205882,

I wanted to see if you got the help you needed. 

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question. 
Of course, if you have more to share on your issue, please pursue the conversation. 

Thanks,
Anurag