cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Can we map assembly based attributes in creo to occurence attributes in Windchill?

KarDehal
6-Contributor

Can we map assembly based attributes in creo to occurence attributes in Windchill?

background - its been years since I've done any serious modeling, but I think this should be possible.

 

When I check in a creo assembly, i want to push the X,Y,Z locations of the origin of each of the children components.

In my mind, this is similar to pushing the find number, line number, or reference designator from an assembly to Windchill.

Ideally, these would be occurence attributes in the part structure.

 

I'm just not sure how to set these parameters/attributes in Creo and how to configure Windchill to recieve them.

 

Any help would be appreciated.

 

Thanks,

Kar

1 REPLY 1

Hi

 

no need to map anything.  It's already there OOTB

 

X,Y,Z and all the posotion Matrix with rotations are already published on occurences.

you can display it in PSB occurence table

 

regards

Announcements


Top Tags