cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

We are happy to announce the new Windchill Customization board! Learn more.

Intralink 10.2 CAD-Worker

Robert-Altman
7-Bedrock

Intralink 10.2 CAD-Worker

If using Windchill/Intralink 10.2 (not pdmlink) can a "CAD Worker" be configured to create exported STEP during the release workflow?

1 ACCEPTED SOLUTION

Accepted Solutions

I don't have access to a Pro/Intralink now to verify, but   this is possible in Windchill where you can create a publishing rule to generate STEP from worker. if you are using promotion object for release, there is a preference that push a publishing right after Promotion creation. If you are using any other workflow, you can trigger a publishing from workflow too.

I believe this is possible in Pro/Intralink as it uses same codebase, just by removing support for enterprise part. More over  PTC has Pro/Intralink in "applies to" of this CS - https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS81396.

So it is a yes

Regards,

Binesh Kumar

View solution in original post

2 REPLIES 2

I don't have access to a Pro/Intralink now to verify, but   this is possible in Windchill where you can create a publishing rule to generate STEP from worker. if you are using promotion object for release, there is a preference that push a publishing right after Promotion creation. If you are using any other workflow, you can trigger a publishing from workflow too.

I believe this is possible in Pro/Intralink as it uses same codebase, just by removing support for enterprise part. More over  PTC has Pro/Intralink in "applies to" of this CS - https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS81396.

So it is a yes

Regards,

Binesh Kumar

Binesh, Once again I can not thank you enough for your help.

Top Tags