Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I am attempting to auto-populate my clients drawing border with Change No. information. I am having difficulty in getting the attributes to map to the CAD parameters and subsequently show on the border itself where the CAD params are called up in a table. Please see the attached .ppt file for further information but any help would be greatly appreciated.
Jay
HI ,
This can be achieved by Customization only, Please refer "Using Pro/ENGINEER® Wildfire™ with Windchill® Windchill 9.1 September 2010" @ page #153.
This will resolve your requirement.