Hi PROS!
Another problem with modelcheck/windchill gatekeeper:
I used to have a condition in condition.mcc and it used to work fine:
IF ( ECAD_PART_TYPE EQ ELECTRICAL ) config=(check/NO_checks.mch)(start/NO_start.mcs)(constant/inch.mcn)(status/APL_status.mcq)
Now we just switched to wc9.1 and gatekeeper does not allow me to check anything in because MC_CONFIG is set
check/APL_checks.mch, start/INWORK_start.mcs, constant/inch.mcn. So, I must go and apply all the start features and parameters to the ECAD models.
I also have few other conditions that makes MC to skip vendor models e.t.c. I can not "fix" all of them just to be able to check them into the plm. Anybody else seen this problem?
What is the solution?
I would appretiate any input!
Dmitry