Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi Guys, I am looking for an Inventor & Solidworks automatic PDF & step conversion through Visualization Configuration Administration.
Regards,
AJ
https://www.ptc.com/en/support/article/CS111916?source=search
https://www.ptc.com/en/support/article/CS81396?source=search
Thanks for sharing @avillanueva
I am currently looking for an Inventor publishing rule, can you please provide it if you have one.
I am confused. This looks like the same thing you were posting last year:
https://community.ptc.com/t5/Windchill/Visualization-Configuration-Administration-INVENTOR/m-p/943969#M79712%3Fsource=search
