Skip to main content
D
draitzyk1-Visitor
1-Visitor
September 26, 2015
Question

Stuck typing symbols in drawing

  • September 26, 2015
  • 1 reply
  • 12072 views

So I am trying to name a 2-D section for one of my drawings on Creo 3.0 and out of nowhere I can only type symbols, but if I hold the shift key I can type upper case letters but when I try to save the section as "A" it says illegal characters entered. Also, instead of a one line blinking cursor when typing it is a thick black box. I have tried creating a new drawing but it does the same thing. Any help would be greatly appreciated.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

P
psobejko1-Visitor
1-Visitor
September 28, 2015

Sounds like you hit CTRL+A combination; that will switch to input the "special symbols".  For example, CTRL+A, then small case 'n' will put in the diameter symbol (Ø).

To exit this mode, you press CTRL+B (but it seems ESC key will also work).  At least this is how it is working in Creo 2.0.

On a related note: once, I got into an input mode where characters were being typed in from right to left.  Does anyone have an idea what key combination I pressed to get into such mess?

    M
    mender12-Amethyst
    12-Amethyst
    September 28, 2015

    Confirming the original issue was about Ctrl-A where Shift-A was intended.

    On the related note:  I don't know how exactly you got there, but where you got was having specified the input language as Hebrew.  Hope that helps!

    Terms & ConditionsAccessibility statement