Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
How to Flattern Part without "Flattern Quilt" Comand in ProE 5.0?
How to Flattern Part without "Flattern Quilt" Comand in ProE 5.0?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
It is highly dependent on the geometry of your part. As Clint mentions, you can convert the part to sheetmetal and then create a flat pattern feature or an unbend.
