Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
シートメタルの作成方法（コマンドの使用方法）がわかるようなテキストはないでしょうか？（Creo2.0）
Solved! Go to Solution.
Translated:
Heading: How to create sheet metadata
Body: Are there any texts that tell me how to create sheet metadata (how to use the command)? (Creo2.0)
View solution in original post
PTC learning exchange has videos for learning sheetmetal. Below is the learning exchange link when I searched for sheetmetal.
Searching for 'sheetmetal'
