cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

2D Mechanism w/mass properties

DanL
1-Newbie

2D Mechanism w/mass properties

Hi everyone,

 

 

I have a 2D mechanism modeling a simple pendulum with a shock/damper mounted at some moment arm from the pivot location. I was wondering if it was possible to add mass and moment of inertia properties in order to run a dynamic analysis of the pendulum. I tried using edit > mass properties then sececting the 'line' as the part and entering a mass and moment of inertia. However, I get an event error that says "The inertia is invalid at the center of gravity. Do you knwo if what I'm trying to do is even possible? I'm just trying to do this so I can quickly change geometries without fussing with solid models.

 

Thanks!

-Dan


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements