Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hi,
I've done a direction pattern with respect to the blue directions (of another object of the assembly) in the picture.
With relations, I want to invert the direction of the pattern in relation to the constraint of the first object of the pattern.
Wich is the command that I have to insert afther the if conditions in the following relations?
Thanks a lot.
Michele Barile
Solved! Go to Solution.
Hi,
you could use a relation like this:
/* PARAMETERS FOR DIMENSIONS PATTERN
1_DIRECTION = 50
2_DIRECTION = 150
/* PARAMETER SET
PARAMETER_SET = 1
/* IF CONDITION
IF PARAMETER_SET == 1
$d4 = 1_DIRECTION
$d5 = 2_DIRECTION
ENDIF
IF PARAMETER_SET == 2
$d4 = - 1_DIRECTION
$d5 = - 2_DIRECTION
ENDIF
Hi MB_10508968,
Thank you for your question.
Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.
Regards,
Vivek N
Community Moderation Team.
Hi,
you could use a relation like this:
/* PARAMETERS FOR DIMENSIONS PATTERN
1_DIRECTION = 50
2_DIRECTION = 150
/* PARAMETER SET
PARAMETER_SET = 1
/* IF CONDITION
IF PARAMETER_SET == 1
$d4 = 1_DIRECTION
$d5 = 2_DIRECTION
ENDIF
IF PARAMETER_SET == 2
$d4 = - 1_DIRECTION
$d5 = - 2_DIRECTION
ENDIF