Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
does anyone know howI get the thread notes generated in my model to transfer into my detailed drawing. I can't seem to find the answer anywhere in the help documentation. I end up putting in the thread designation in a note in the detailed drawing. it has to be easier than this.
Dave
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
You need to go into View on the Menu and then select Show/Erase, Select the notes Button and this will show up the note orinating from the model. Hope this helps
