Question
Analysis of the welds
I need to simulate a complicated (curvature of the surfaces) welded assembly. Are welds will be analyzed, if I will add the welds to the assembly in Creo Simulation? How can I specify the parameters of the welds (cross section), and the materials? Am I needed to model it ONLY in Creo parametric as additional components of the assembly (which is a very time consuming)? I did it without any problems in SolidWorks, but faced a huge problem using Creo.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.