Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
How do you create and angled datum plane in creo 3.0. It is not the same as Creo 2.0 where you select the two planes by holding down the control key. This does not work. Any ideas?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
from my point of view angled datum plane goes thru axis/linear edge and hold angle to existing datum plane/planar face. So you have to select axis+datum plane to create new angled datum plane.
