Appearance Decal Graphics setting issue - Decal fails to display properly in Creo 4

[danders238]

Hi,

I have run into this issue before and haven't been able to find the setting to fix the issue.

I have a workstation with a RTX2080TI NVIDIA graphics card running Creo 4.

The surface in the attached image should show a single line drawing in the view in the upper right corner of the image.
Anyone know how to fix this and what the config.pro settings should be?
Thank you!

Don

[MartinHanak]

---

@danders238 wrote:

Hi,

I have run into this issue before and haven't been able to find the setting to fix the issue.

I have a workstation with a RTX2080TI NVIDIA graphics card running Creo 4.

The surface in the attached image should show a single line drawing in the view in the upper right corner of the image.
Anyone know how to fix this and what the config.pro settings should be?
Thank you!

Don

---

Hi,

to display image properly I had to place it onto datum plane offset by 0.01 mm from model surface.

[danders238]

Hi Martin,

When I apply the image It repeats the image multiple times across the surface.
Is there a way to prevent this from happening?

This is what it looks like

This is what it should look like below

Thanks for any help you can provide!

Don A

[MartinHanak · Accepted solution]

---

@danders238 wrote:

Hi Martin,

When I apply the image It repeats the image multiple times across the surface.
Is there a way to prevent this from happening?

This is what it looks like

This is what it should look like below

Thanks for any help you can provide!

Don A

---

Hi,

I guess it is graphic card driver problem.

If I were you I would try setting following config.pro option temporarily

graphics  win32_gdi

If this setting resolve the problem, then you have to experiment a little ... download and install several graphic card driver version and test their functionality. Of course, you can open case at PTC Support !

... and you cal also test following config.pro options (see https://support.ptc.com/appserver/cs/view/solution.jsp?source=subscription&n=CS169272 )

enable_opengl_fbo no
enable_opengl_vbo no
enable_opengl_shader no

[danders238]

Hi Martin,

Thank you very much for your help!!!!!!

The following 3 options have me back up and running again
enable_opengl_fbo no
enable_opengl_vbo no
enable_opengl_shader no

Thank you!!!!

Don A