Applying Stress/Strain as loads in Creo
‎Aug 11, 2014
05:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 11, 2014
05:17 PM
Applying Stress/Strain as loads in Creo
Hello,
I am new to modeling and simulation and I was wondering if it is possible to apply Stress or Strain loads instead of the standard force etc. loads in creo. I want to simulate shot peening and would like to use a residual stress field or plastic deformation field to apply my loads but I cannot seem to find a way to apply Stresses and Strains.
Thanks
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
‎Aug 12, 2014
04:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 12, 2014
04:07 AM
Could it work by using a (huge) pressure load ?