cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Area of a Cosmetic Sketch

mjenkins
5-Regular Member

Area of a Cosmetic Sketch

Is there an easy way to calculate the hatched area of a cosmetic sketch?

(other than creating a protrusion of it and measuring it's area)

Michael R. Jenkins P.E.
Design Engineer
Direct: 816-801-2332
Fax: 816-891-9432

Commercial Vehicle Systems
Haldex Brake Products Corporation
10930 North Pomona Avenue
Kansas City, MO 64153-1215


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
5 REPLIES 5

Hi Michael,

Print it out along with a 1 X 1 square, cut them both out and weigh them on a milligram scale.

That's how those wacky calculus doctors do it to check that their approximations are valid.

Otherwise, extrude it baby!

Pro/E will do a cross-sectional area, but not with a cosmetic.

Best regards,

Frederick Burke


Hi Michael,
Simpler than extruding using the sketch is to highlight the sketch feature
and make a fill (flat surface) then you can get the area or perimeter of the
surface. Does not leave you with a meaningless extrude if you don't need
one. Redefine the sketch and the Fill surface updates automatically. I
would name the fill as an Area feature.
Of course you could pick fill then choose the sketch but that takes a couple
more steps.


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com


wfalco
15-Moonstone
(To:mjenkins)


I tried this earlier and it works nice.

mjenkins
5-Regular Member
(To:mjenkins)


Genius! That works great!


In Reply to Brent Drysdale:

Hi Michael,
Simpler than extruding using the sketch is to highlight the sketch feature
and make a fill (flat surface) then you can get the area or perimeter of the
surface. Does not leave you with a meaningless extrude if you don't need
one. Redefine the sketch and the Fill surface updates automatically. I
would name the fill as an Area feature.
Of course you could pick fill then choose the sketch but that takes a couple
more steps.


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com


I could do this on a sketch, but not a cosmetic sketch. Am I doing something wrong?


Doug Pogatetz
Mechanical Design Engineer
WF4 M070


Top Tags