Assembling Config Option

[ErikZabokrtsky]

Can someone point me in the direction of the config option that controls when we "assemble" a component into the assembly if it is attached to the cursor or not.  We have 3 users, that the part is attached to the cursor and places where they click and we are troubleshooting an issue with this.

Thanks,

Erik

[StephenW · Accepted solution]

Look at the option: comp_assemble_start

[ErikZabokrtsky]

That was it! Now can you tell me why having this set to "move_then_place" will lock Creo 3.0 up for 5 minutes, but setting it to "default" works flawlessly? Haha. Just started happening in the last 2 weeks and we have done no updates to anything.

[StephenW]

Unfortunately I don't know why it would add excessive time to assemble a component.

I do know that component interfaces that look for automatic placement add a lot of time to assembly.