I was wondering how auto place is working for people. I was trying out
auto place in Wildfire 4 and it seems a bit flakey. I was trying to
place a cap screw in a hole and was having less than stellar success.
If I clicked near a hole on a thin sheetmetal part in an assembly it
would often come up with a hole deeper (into the screen-wise) in the
assembly. When it did get the right hole it would come up with a
solution where the screw was up side down but not offer a solution for
right side up.
Thanks,
Michael Cormack
NACCO Materials Handling Group
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.