Good Morning Everyone,
In Creo Parametric Drawing Mode, Would there be a way to continually place balloons on the drawing where each time you place a balloon the value keeps increasing?
Like what you would do in a inspection report or tolerance stack up to identify each dimension on the drawing?
Thanks
Don Anderson
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
