Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Dear Friends,
I am currently working in Creo Elements WF 5.0. I am facing an issue in detailing procedure, especially drafting. While creating Balloon notes, I am able to define the balloon radius globally by altering the "min_balloon_radius" and "max_balloon_radius". But I need to change the balloon radius individually. Kindly guide me on how to change the balloon radius individually.
Please note : This is not a BOM balloon.
Thanks in advance!
Regards,
Prashanth Gb