I know it has been asked before and there is smoke and mirrors involved, but
are there any new tricks to getting bitmaps to show up in drawings. I know
it is related to the OLE interface and was wondering if anyone has found a
way to repair this problem in WF4.
--
Ron Rich
Staff Mechanical Engineer
Keithley Instruments
28775 Aurora Rd.
Solon, OH 44139
PH. 440-498-2842
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
