Hello,
I have a GA drawing with several sub-assemblies comprising a bolt, a nut and
2 washers.
I have been asked to annotate the drawing with a BOM balloon showing the
item number and, in the case of the washers, a note showing quantity '2 in
24 places'. Pro/E, naturally, wants to show a quantity of 48. I have created
a teeny tiny detail view, which I have placed off the drawing format, and
placed the BOM balloon on that detail view. I then split the balloon
quantity, and put another balloon with a quantity of 2 on the main drawing.
Finally, I created a note which referred to the pattern parameter to yield
the '24 places'. Naturally, I related the note to the balloon.
Is this the best way, or is there a cunniing method that I have not thought
of?
WF2, M220
Thanks,
John
John Wayman, C.Eng, FIED
Senior Mechanical Engineer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
