Good afternoon,
When I used to produce a broken view on a drawing board, I would put a
matching break in any dimension that went across the break in the view.
When I create a broken view in a drawing in WF2, the dimensions I show are
continuous across the break.
Is there a config option for this, or is it 'intended functionality'?
Regards,
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
