cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

CREO 3 is running very slowly

ehoffman-3
1-Visitor

CREO 3 is running very slowly

Even though my CPU is running well within range while program is open (rarely over 40-50%), the program is running very slowly. The disk runs high as expected until program is open, then it goes back down to a low percentage of use. I have an i7-5500U @2.4GHz processor with 8GB ram.... any suggestions???

ACCEPTED SOLUTION

Accepted Solutions
StephenW
23-Emerald III
(To:ehoffman-3)

Typically its a graphics card issue... Creo 2.0 incredibly slow on Lenovo Y510P

First try updating your graphics card drivers.

2nd try adding the following option to the config.pro  There are specific instructions on how here: Re: Creo 2.0 Parametric Running Slow

graphics  win32_gdi

View solution in original post

2 REPLIES 2
StephenW
23-Emerald III
(To:ehoffman-3)

Typically its a graphics card issue... Creo 2.0 incredibly slow on Lenovo Y510P

First try updating your graphics card drivers.

2nd try adding the following option to the config.pro  There are specific instructions on how here: Re: Creo 2.0 Parametric Running Slow

graphics  win32_gdi

Updated my graphics drivers, soooooooooo smooth! thank you!!!

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags