I was just wondering that is it possible to find the developed length ? Say i create a sheet metal with 10 punch form.... then during the operation the metal deformation will take place so finally i need a sheet metal larfer than original one? How to achieve it?
My initial and final measurement remains same Example in image is shown.....Also please correct me if i am wrong in concept
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
