On a sheet metal drawing, there are holes and slot hole. I found that Creo did not recognize the center line or axis of the slot hole. How can I make these center line shown on the drawing or the best way to solve it? Thanks.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Add two points (geometry points, not construction points) in the extrude slot feature's sketch where your centers are; These will turn into datum axes when extruded; then show them on the drawing as needed.
Add two points (geometry points, not construction points) in the extrude slot feature's sketch where your centers are; These will turn into datum axes when extruded; then show them on the drawing as needed.
