I'm trying to make this cut on both sides of this part. In the assembly, I added the tip piece, did the component->cut out op, and hid the piece. I then did the same thing to the other side with a mirror image of the piece, and then hid that one too.
Only it won't hide completely. You can see where one side is semi-tranparent, but it won't hide the entire part and I don't know why. It doesn't matter what side I do first, when I'm done with both, the side I did last will not hide completely. The tip pieces do not touch when assembled so there is no interference.
Any asssitance would be greatly appreciated and thank you.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
