cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

Contact surface area error

dmaynard
12-Amethyst

Contact surface area error

What does it mean when I get the error: "Cannot process highlighted contacting surfaces. Source:Geometry" during an AutoGEM Mesh. Attached is a picture showing the error and the surfaces involved. I tried setting up the contact area as an interface and that did not correct the issue. Any ideas?

ACCEPTED SOLUTION

Accepted Solutions
dmaynard
12-Amethyst
(To:dmaynard)

Steven,

I took your advice and built the model using the beam idealization. It was faster and much easier to run the simulation. It took me some time to learn how to do it but it is easier.

Thanks.

View solution in original post

3 REPLIES 3
DenisJaunin
15-Moonstone
(To:dmaynard)

Hi Damian,

We do not see the connection between your joists.

Do you have a view of the normal assembly, not Simulate.

Sincerely.

Denis.

The connections are all bolted. I am running the simulation using pin constraints at all the bolt holes just to see if I get a good mesh before I add the fasteners. Think that may be affecting the simulation?

dmaynard
12-Amethyst
(To:dmaynard)

Steven,

I took your advice and built the model using the beam idealization. It was faster and much easier to run the simulation. It took me some time to learn how to do it but it is easier.

Thanks.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags