cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Creating geometry from curve from cross section

Osiel_G
8-Gravel

Creating geometry from curve from cross section

I have been trying to make any kind of flat surface or extrusion from a cross section without success, I have an assembly and from that assembly I am creating the cross sections then the curves from them, i don't want to use a sketch because this curves can change drastically then the extrude starts to complain.

On the image below (front view) the two "hills" can change to be from one to ten, so one curve feature may have one to several closed loops.

From this loops i just need to have a solid extrude either 2 or 4 inches tall.

 

MATL-PREP (Active) - Creo Parametric.jpg

 

My goal is to have something like the image below and that can be updated without major issues

2018-08-15 07_53_57-TRC00000_AUTOCUTS (Active) - Creo Parametric.jpg

Any ideas??

Thanks!!

Osiel Gaona

 

 

2 REPLIES 2
John.Pryal
12-Amethyst
(To:Osiel_G)

Maybe a little late in the day for a solution to your problem but i thought i would have a go. Perhaps the attached model maybe of use to you.

 

Best regards

John

Thanks, I tried it but this is not what I was looking for, anyway management change their mind.

Top Tags