Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
Has anyone experienced issue with balloons in Creo 2 (M010), where Edit Attachment does not highlight or let you select edges on the part in an assembly? We've also had the opposite happen, where Edit Attachment allows you to pick any edge from any part. The balloons are also not highlighting the item line in the table either.
The balloons are being created from a drawing table, using the "All" option.
Any ideas?
Dave Clark CAD Application Engineer Dukane Corporation Intelligent Assembly Solutions Division 2900 Dukane Drive St. Charles, IL 60174 630-797-4922 (Phone) 630-797-4949 (Fax)
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
