cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo 7 Piping

SV_8732919
4-Participant

Creo 7 Piping

I am using Creo Parametric 7.0 7.0.4.0

If a part is created with reference to a red segment(Snap1). Now, I want to select a new segment. When i try to edit the SOlid pipe, I am not able to select a new segment, which was possible in earlier versions. In creo 7 the segments are considered as part of the body due to which it does not allow to replace the existing segment with the new one.

If we try to replicate in Creo 4, it works well

1 ACCEPTED SOLUTION

Accepted Solutions
haizhang
15-Moonstone
(To:VladimirN)

Issue resolved in Creo Parametric 7.0.6.0.

View solution in original post

2 REPLIES 2

Try "Open a Support Case", here: https://www.ptc.com/en/support/case-logger

haizhang
15-Moonstone
(To:VladimirN)

Issue resolved in Creo Parametric 7.0.6.0.

Top Tags