Community Tip - Your Friends List is a way to easily have access to the community members that you interact with the most! X
Hi folks,
Does anybody else find it a bit odd that you can't do anything with a sheetmetal part in Creo Direct?
My expectation would have been that I could at least do some simple geometry in Direct, but I can't even open a sheetmetal part from Parametric.
Below is the error you get in Creo 2.0 Direct when attempting to open a Sheetmetal part from Creo 2.0 Parametric.
I did my best to find any sort of documentation to state what Direct does and does not do, but I couldn't find any. Only thing I found was a forum post that implied that it may be possible to work with sheetmetal parts in Creo Direct.
(Really, not trying to stir the kettle!)
Josh