Creo View 3 M020

[llie]

Has anyone implimented Creo View 3? In sectining, you do a "Show 2D View" and the 3D & 2D views are side by side. Once you close the 2D view, the 3D view still stays half screen and there is no way to make it full screen again.

You have to close out of Creo View and then open it back upor add a new file to a new session from PDM Link.

Has anyone else seen this behavior. Opening a defect with PTC.

Lance

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomU]

Double click on the blue bar or right click and choose "maximize". This is with Creo View 3.0 M020

Tom U.

[cid:image002.jpg@01CFAA85.6E5A7CF0]

[llie]

Tom,

Thank you for coming to the rescue. You would think PTC would add an icon
and make it a little more obvious.

Lance Lie
Sr. Info Sys Technologist II
Global Business Services - Information Technology
Raytheon Company



714-446-2806 (office)
714-402-7858 (cell)
-

1801 Hughes Way
Fullerton, CA 92833 USA
www.raytheon.com

This message contains information that may be confidential and privileged.
Unless you are the addressee (or authorized to receive mail for the
addressee), you should not use, copy or disclose to anyone this message or
any information contained in this message. If you have received this
message in error, please so advise the sender by reply e-mail and delete
this message. Thank you for your cooperation.