cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Creo / WF 5.0 Graphics problem

DanielYoder
Newbie

Creo / WF 5.0 Graphics problem

Hi All,

I have a T60 Lenovo laptop with CREO 2.0 and WF 5.0 installed. In CREO when I zoom in on an assembly, or a part, the geometry of the part if in the upper top of the screen or either side does a blur, like it gets extruded upward. The same assembly on the same laptop does not do this. Any ideas what I can do?

TIA Cadmandu


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Re: Creo / WF 5.0 Graphics problem

Just a though -- I had some unexpected problems with graphics on my Lenovo laptop. I went to the Lenovo site and downloaded and installed an updated video drive, and all was well.

Re: Creo / WF 5.0 Graphics problem

On my desktop the same thing is happening.

Announcements